Altec Lansing Portable Stereo System IN MOTION User Manual

4.3

Out of 5 Ratings

Owner's of the Altec Lansing Portable Stereo System IN MOTION gave it a score of 4.3 out of 5. Here's how the scores stacked up:

  • Reliability

    4.6 out of 5

  • Durability

    4.4 out of 5

  • Maintenance

    4.2 out of 5

  • Performance

    4.8 out of 5

  • Ease of Use

    3.67 out of 5
of 76
 
13
EN
If you have a non-iPod MP3 player or other non-docking portable audio
device, you can enjoy it through your Altec Lansing inMotion Kick speaker
system as well. Just connect it via the AUX jack. Here’s how:
1 Locate a 3.5mm stereo cable
(notincluded).
2 Plug one end of the stereo cable
into your device.
Your device should have either a
headphone or LINE OUT jack for you
to plug into.
3 Plug the other end of the stereo
cable into your speaker system’s
AUX jack.
The AUX jack is located on the back
ofthe unit.
4 Select “AUX” mode.
Press the “SOURCE” button on your
speaker system or the full-featured
remote until the “AUX” LED lights up.
5 Turn on your device and start it
playing.
6 Adjust the volume.
Use the “+” and “–” buttons on the speaker system or full-featured
remote to adjust the volume.
NOTE You may need to adjust the device volume also. Your device’s
volume should be set to approximately ¾ volume.
7 When you are finished listening to your portable audio device,
please remember to turn both it and your speaker system off
to conserve electricity.
Maintaining Your Speaker System
Place your speaker system on a level surface away from sources of direct
sunlight or excessive heat.
Protect your furniture with a cloth or other protective material when placing
your speaker system on a natural wood or lacquered finish.
Clean your speaker system with a soft cloth moistened only with mild soap
and water. Stronger cleaning agents, such as benzene, thinner or similar
materials, can damage the surface of the unit.
Listening to a Non-docking iPod or Other Portable Audio Device

   Find Your Products By Category