Eclipse - Fujitsu Ten GPS Receiver CD5030 User Manual

0

Out of 0 Ratings

Owner's of the Eclipse - Fujitsu Ten GPS Receiver CD5030 gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 113
 
How to operate the Sound Adjustment Mode
71
XII
The measurement result can be
referred to when adjusting parametric
equalizer.
ATTENTION
Bluetooth is temporarily disconnected while
measuring frequency characteristics.
Changing the equalizer mode
(Auto EQ) based on the
measurement result
Each time this button is pressed, the
equalizer mode is toggled as follows:
ON ↔ OFF
ON:
AUTO.EQ mode
OFF:
Manual mode
ATTENTION
You can set the 7-band parametric equalizer in
the AUTO.EQ mode to more effectively
configure the desired acoustic settings.
Time alignment adjustment (Time
Alignment)
The delay time and level of the sound from each
speaker can be adjusted in order to correct any
phase mismatches in the sound resulting from
the listening position. You can automatically
adjust them if the optional measurement
microphone (MEI-100) is connected.
Manually adjusting Time Alignment
The time alignment setting mode is
activated.
Each time the button is pressed, the
band changes in the following order.
Front Left → Front Right → Rear Left →
Rear Right → Non-Fader → Front Left www
The delay time can be adjusted within
0.0 to 10.0 ms (0.1 ms for the main
unit).
[>]:
Increases the time.
[<]:
Decreases the time.
1
Press button [6].
1
Select "Time Alignment" by
pressing the [ ] or [ ] button.
2
Press the [ENTER] button.
3
Press the [ENTER] button to select
the speaker band to be adjusted.
4
Adjust the time delay in the arrival
of the sound by pressing the [<]
or [>] button.

   Find Your Products By Category