4.1
Owner's of the Genie Utility Vehicle GS-2032 gave it a score of 4.1 out of 5. Here's how the scores stacked up:
Part No. 82784 Genie GS-2032 and Genie GS-2632 19
Operator's Manual
Second Edition • Second Printing
FUNCTION TESTS
32 Press the drive function select switch.
33 Press and hold the function enable switch on the
control handle. Slowly move the control handle
to the full drive position.
Result: The maximum achievable drive speed
with the platform raised should not exceed
23 cm per second.
If the drive speed with the platform raised exceeds
23 cm per second, immediately tag and remove the
machine from service.
Test the Tilt Sensor Operation
Note: Perform this test from the ground with the
platform controller. Do not stand in the platform.
34 Fully lower the platform.
35 Place a 2x4 or similar piece of wood under both
wheels on one side and drive the machine up
onto them.
36 Raise the platform approximately 2.1 m from the
ground.
Result: The platform should stop and the tilt
alarm will sound at 600 beeps per minute.
37 Move the drive control handle in the direction
indicated by the blue arrow, then move the drive
control handle in the direction indicated by the
yellow arrow.
Result: The drive function should not work in
either direction.
38 Lower the platform and remove both pieces of
wood.
Test Drive and Braking
27 Press and hold the function enable switch on the
control handle.
28 Slowly move the control handle in the direction
indicated by the blue arrow on the control panel
until the machine begins to move, then return
the handle to the center position.
Result: The machine should move in the
direction that the blue arrow points on the
control panel, then come to an abrupt stop.
29 Slowly move the control handle in the direction
indicated by the yellow arrow on the control
panel until the machine begins to move, then
return the handle to the center position.
Result: The machine should move in the
direction that the yellow arrow points on the
control panel, then come to an abrupt stop.
Note: The brakes must be able to hold the machine
on any slope it is able to climb.
Test Limited Drive Speed
30 Press the lift function select button.
31 Press and hold the function enable switch on the
control handle. Raise the platform approximately
1.2 m from the ground.
Result: The pothole guards should deploy.
Find Your Products By Category
Please Login
