Genie Utility Vehicle GS-4390 User Manual

0

Out of 0 Ratings

Owner's of the Genie Utility Vehicle GS-4390 gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 36
 
Part No. 82828 Genie GS-3384 & GS-3390 & GS-4390 & GS-5390 19
Operator's Manual
Second Edition • Third Printing
FUNCTION TESTS
Test the Up Limit Switch and the Outriggers -
GS-5390
34 Push and hold the lift function enable button.
Raise the platform.
Result: The platform should raise to 9.1 m and
then stop. The platform should not raise above
9.1 m unless the outriggers are lowered.
35 Drive the machine forward.
Result: The drive function should not operate.
36 Lower the platform. If the platform is higher than
3.6 m from the ground, the outriggers will not
lower.
37 Push and hold the auto level
button.
38 Activate the up/down rocker switch in the down
direction.
Result: The outriggers should extend and level
the machine. A beep will sound when the
machine is level.
39 Raise the platform.
Result: The platform should raise to full height.
40 Lower the platform.
41 Push and hold the auto leve button and raise the
outriggers.
Test the Tilt Sensor Operation
Note: Perform this test from the ground with the
platform controller. Do not stand in the platform.
42 Fully lower the platform.
43 Drive both wheels on one side onto an 18 cm
block.
44 Raise the platform at least 3.6 m.
Result: The platform should stop and the tilt
alarm will sound at 180 beeps per minute. The
indicator light on the lift function enable button
will be red.
45 Move the drive control handle in the direction
indicated by the blue arrow, then move the drive
control handle in the direction indicated by the
yellow arrow.
Result: The drive function should not work in
either direction.
46 Lower the platform and drive the machine off the
block.
Test Auxiliary Lowering
47 Push and hold the lift function enable button and
raise the platform approximately 60 cm.
48 Push in the red Emergency Stop button to shut
off the engine.
49 Pull out the red Emergency Stop button to the
on position.
50 Push and hold the lift function enable button.
Activate the up/down rocker switch in the
direction indicated by the yellow arrow.
Result: The platform should lower.

   Find Your Products By Category