Sanyo Flat Panel Television Vizzon User Manual

3.9

Out of 27 Ratings

Owner's of the Sanyo Flat Panel Television Vizzon gave it a score of 3.9 out of 5. Here's how the scores stacked up:

  • Reliability

    3.92 out of 5

  • Durability

    3.85 out of 5

  • Maintenance

    3.81 out of 5

  • Performance

    3.89 out of 5

  • Ease of Use

    3.81 out of 5
of 52
 
2
Connect Signal to the DTV’s Integrated
Analog / Digital 75 ohm Antenna Input
terminal.
5
Need help?
Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032
GETTING STARTED
(REQUIRED INITIAL SETUP)
1
Install batteries in remote
control (2AAA, not included).
3
Connect AC Power Cord (supplied) to the
Plasma DTV and electrical outlet as shown
here.
The AC outlet must be near
this equipment and must
be easily accessible.
5
Perform “All Channel Search.” The All Channel
Search will search for off-air digital and analog
channels, and analog cable channels. The DTV
can receive cable or off-air channels, but not at
the same time. If after two searches the DTV
still fails to detect any
channels, the DTV will
tune to Video1.
PRECAUTIONS
To ensure safe operation, please observe
the following precautions:
Replace both batteries at the same time. Do
not use a new battery with a used battery.
Risk of explosion, if battery is replaced by
an incorrect type.
Do not expose the Remote Control Unit to
moisture or
heat.
RF ANTENNA
CABLE
OR
CABLE BOX OR SATELLITE BOX
OR
ANALOG/
DIGITAL
ANTENNA IN
THE TUNER IN THIS PLASMA DTV CAN RECEIVE:
1. Digital and / or Analog Off-Air Signals from an RF
antenna.
OR
2. Analog or ClearQAM cable channels.
Note: You must search for ClearQAM channels using
the “Digital Cable Search” menu option.
OR
3. The output from a VCR or cable box.
Digital signals can also be received through the HDMI
jacks.
Signals from a Set-top (STB) Box should be received
through the Video 1, 2, or 3, or HDMI Input 1, 2, or 3
jacks.
This DTV can receive ANY unscrambled RF signal
being broadcast.
Match the “+” and “–” signs
on the batteries with marks
inside the remote control.
To 120 V AC outlet.
INITIAL ON-SCREEN
ALL CHANNEL SEARCH
4
Press the POWER key. (Follow on-screen
instructions).
ANALOG CHANNELS
Note: If
EXIT
is pressed,
the DTV will skip Channel
Search and tune to Video1
without storing any chan-
nels in the Channel Map
database.
To POWER CORD
CONNECTOR on
back of Plasma DTV.
DIGITAL CHANNELS
➠

   Find Your Products By Category