Genie Utility Vehicle Z-60, Z-34 User Manual

3.0

Out of 1 Ratings

Owner's of the Genie Utility Vehicle Z-60, Z-34 gave it a score of 3.0 out of 5. Here's how the scores stacked up:

  • Reliability

    3.0 out of 5

  • Durability

    3.0 out of 5

  • Maintenance

    3.0 out of 5

  • Performance

    3.0 out of 5

  • Ease of Use

    3.0 out of 5
of 41
 
Operator's ManualSixth Edition · Second Printing
Part No. 1000209 Z-60/34 19
Test Auxiliary Controls
13 Turn the key switch to ground control and shut
the engine off.
14 Pull out the red Emergency Stop button to the
on position.
15 Simultaneously hold the
auxiliary power switch on and
activate each boom function
toggle switch.
Note: To conserve battery power, test each
function through a partial cycle.
Result: All boom functions should operate.
At the Platform Controls
Test Emergency Stop
16 Turn the key switch to platform control and
restart the engine.
17 Push in the platform red Emergency Stop
button to the off position.
Result: The engine should turn off and all
functions should not operate.
Deutz Diesel models: The engine will shut off
after 2 or 3 seconds.
18 Pull out the red Emergency Stop button and
restart the engine.
FUNCTION TESTS
Test the Machine Functions
7 Do not hold the function enable
switch to either side. Attempt to
activate each boom and platform
function toggle switch.
Result: All boom and platform functions should
not operate.
8 Hold the function enable switch to either side
and activate each boom and platform function
toggle switch.
Result: All boom and platform functions should
operate through a full cycle. The descent alarm
(if equipped) should sound while the boom is
lowering.
Machines equipped with Platform Level Control
Disable Function: The platform level toggle switch
will not operate when the primary boom is raised or
extended or the secondary boom is raised past the
drive speed limit switches.
Test the Tilt Sensor
9 Pull out the platform red Emergency Stop
button to the on position.
10 Turn the key switch to platform control.
11 Open the control panel side
turntable cover and locate the
tilt sensor next to the control
box.
12 Press down one side of the tilt
sensor.
Result: The alarm, located in
the platform, should sound.

   Find Your Products By Category